UBUNTU 11.10 STARTUP MANAGER HOW TO
UBUNTU 11.10 STARTUP MANAGER INSTALL
UBUNTU 11.10 STARTUP MANAGER FULL
UBUNTU 11.10 STARTUP MANAGER WINDOWS 10

Once you’ve installed it, launch it from the Desktop Dash or use the following command.

UBUNTU 11.10 STARTUP MANAGER INSTALL

Open the terminal by hitting “ Ctr + Alt + t” and run the following command to install Pybackpack backup manager tool under Ubuntu 12.10/12.04/11.10 and Linux Mint 14/13/12 $ sudo apt-get install pybackpack This is very crucial in terms of saving disk space and network bandwidth.

UBUNTU 11.10 STARTUP MANAGER FULL

The benefit of using rdiff-backup is, it do full backup at first time and later backups it takes only updated files. The pybackpack tool uses back-end as rdiff-backup program for backups. The interface is pretty simple and provides a good design which makes the whole process user friendly and much easier. Like you do for other backup applications. That’s great, but it will not create a separate partition for your files and folders.Pybackpack is an open source simple, powerful and user-friendly file backup utility was written for Gnome desktop only and released under the GPL, but you can also use it for other desktops too.

UBUNTU 11.10 STARTUP MANAGER WINDOWS 10

The installer should detect that Windows 10 is already installed and offer to install Ubuntu 16.10 alongside it. I suggest you select that option, play around with the Live desktop, and if you’re satisfied, launch the installer by clicking on its icons on the dock or on the desktop.Īfter the installer starts, click through the first few steps until you get to the one shown in Figure 1. One of the entries will be to boot into the Live desktop. If the computer has been set up to boot from external media, you should see the Ubuntu 16.10 boot menu. In the next step, you’ll use that bootable USB stick to install Ubuntu 16.10 alongside Windows 10. When you’ve finished creating the installation media, insert it into the appropriate port in your computer and reboot. Yours might not be sdb, so verify before copying and pasting # This command assumes that you're executing it from your Download directory And from any Linux distribution, the simplest method is to use the following command: From Windows 10, use this article as a guide to create a bootable USB stick of Ubuntu 16.10. The next step in this operation is to download an installation image of Ubuntu 16.10 desktop from here, then transfer it to a USB stick. Ubuntu 16.10 will be installed in the Unallocated disk space.įigure 1: Windows 10 partitions and the free disk space for installing Ubuntu 16.10 Download Ubuntu 16.10 and Create a Bootable USB Stick When completed, the partition should show partitions and free disk space similar to the one shown in Figure 1. Getting that done is fairly simple by using Windows 10 partition manager. After that, you need to free up disk space from your computer by shrinking the C drive or other partition with enough free space on it. From the BIOS or UEFI setup utility, configure the computer to boot from external media.ģ.

Owners of a Lenovo G50 laptop should consult this guide.Ģ. How this is done depends on your computer, but if you have the same HP 250 G5 laptop I used for this tutorial, see this article.

For a pain-free and successful operation of the sort that you’re about to undertake, it is recommended that you disable Secure Boot ( Restricted Boot). First Step – Get Your Windows 10 Computer Readyġ. The computer used for this article is an HP 250 G5 laptop with Secure Boot disabled.

UBUNTU 11.10 STARTUP MANAGER HOW TO

This post shows how to dual-boot Ubuntu 16.10 and Windows 10 on a computer with UEFI firmware and on a single hard drive.

Ubuntu 11.10 startup manager